| 81280 |
EZ CAM XR (16MM - PAIR)
|
1. Take
alignment readings and determine amount of camber change needed.
2. Raise vehicle by body pinch welds. Remove tire and wheel assembly.
3. Remove the upper strut-spindle bolt. Line up small tab with cam on
bolt. Install bolt with large tab out toward wheel for positive camber
or in away from wheel for negative camber. Add lock nut, snug, but do
not tighten. Loosen the lower bolt.
4. Reinstall tire and wheel assembly and recompensate alignment
equipment. Rotate EZ Cam XR bolt to obtain desired camber reading.
Torque bolts as follows (do not exceed):
#81280 @ 125 ft. lbs. (170Nm)
Always check for proper clearance between suspension components and
other components of the vehicle.
5. Complete alignment and road test vehicle.
|
 |
|
